If you're suffering from leaves or water blowing under your door this could well be a good solution.

This seal comes in 2.44m (8ft) lengths and it comes with its own glue to stick it down to the garage floor, the door then seal up against it.

The high visiblilty yellow stripe along the length will make it easy to spot and avoid tripping over!

The seal is 15mm high and is suitable to be used with all garage doors. If you need a length over 2.5m then you will need to purchase 2 lengths.

Please note - The garage door floor needs to be dry and free of dust for the glue to work effectively!

FLOOR SEAL FITTING INSTRUCTIONS :- Please Note: Floor surface must be clean and dry and free from dust before fitting floor seal. Tools Required: Tape measure, Hacksaw or Large Scissors, Pencil or Marker Pen.

1, MEASURE INSIDE THE GARAGE DOOR WIDTH FROM BRICK PILLAR TO BRICK PILLAR (i.e. Total width including door frame) AND CUT SEAL LENGTH TO SIZE. 2, LAY THE SEAL ONTO THE FLOOR AND WITH THE DOOR IN A CLOSED POSITION PUSH THE THIN EDGE OF THE SEAL UNDER THE DOOR UNTIL SNUG.

3, WITH A PAIR OF LARGE SCISSORS OR A HACKSAW CUT OUT A RECESS IN BOTH EDGES TO ALLOW FOR DOOR FRAME. 4, PUSH THE SEAL BACK INTO POSITION UP AGAINST THE DOOR, MAKING SURE THE SEAL IS STRAIGHT ALONG ITS FULL LENGTH.

5, USING A PENCIL OR A MARKER, MARK A LINE ALONG THE INSIDE EDGE OF THE SEALS LENGTH, THEN OPEN THE DOOR AND CAREFULLY MARK ANOTHER LINE ALONG THE OUTSIDE EDGE. 6, REMOVE THE FLOOR SEAL AND USING THE FIXING ADHESIVE SQUEEZE OUT TWO LINES OF ADHESIVE ROUGHLY 10mm INSIDE EACH LINE, THEN USE THE REMAINING ADHESIVE BY LAYING A ZIG ZAG PATTERN OF ADHESIVE ALONG THE FULL LENGTH IN BETWEEN.

7, CAREFULLY LAY DOWN THE FLOOR SEAL ONTO THE ADHESIVE AND FIRMLY PRESS DOWN, ALLOW 24 HOURS BEFORE DRIVING OVER THE SEAL.